How to Do Drywall Installation
When starting a drywall installation project, it is important to measure the area of the wall thoroughly. You should measure the wall area from the middle of the joists to the ceiling. Once you have this information, cut drywall sheets to the desired length. You will need to mark the drywall sheet with a pencil so that you will know where to cut.
You will need a drywall square and utility knife. You’ll also need a stud finder to find the studs. If your walls are not straight, some studs may be a few inches off center. This can be caused by sloppy carpentry work. If you find a stud that is not straight, it’s important to cut the drywall to fit in it.
Before applying the drywall, you should make sure the framing is level and straight. Otherwise, the drywall may not adhere properly to the wall. You can also use a square to mark the location where the joists intersect with the walls. This step is important for a smooth finish and a proper drywall installation.
Drywall is a common material in homes, but it’s susceptible to damage due to moisture, wall decorations, and general wear and tear. If you need drywall installation services, contact your local Mr. Handyman to help you out. He or she will be able to do the job for you at a much lower cost than you would if you hire a professional drywall installation company.
Generally, you need to apply three layers of drywall mud and one layer of drywall tape. The first layer is called the tape coat and should be about four inches wide. It should be applied evenly to the joints. The second layer is called the block coat. The final layer should be smooth and should have a consistency similar to peanut butter.
If you don’t want to do the work yourself, drywall installation can be done in a DIY manner, though it will require careful planning. You must be sure to take measurements correctly and purchase the right materials. However, if you have a high ceiling, it might be better to hire professional crews. Professionals can complete this task more quickly and efficiently.
You should also purchase special drywall trims to simplify the process. These trims come in plastic or metal and are used to trim the drywall. While most profiles are available as nail-on and tape-on style, you can also find specialty profiles that will fit the area you need to trim. If you do not want to deal with the hassle of miter-cutting, you should go with a pre-cut drywall trim.
Using a professional drywall installer can save you a lot of time and money. The cost per square foot is approximately $0.40 to $0.65 per square foot. It is generally less expensive to purchase drywall panels in large areas. You can also opt for hand-applied textures, which are used for decorative purposes. When it comes to cost, covering a whole house at once is a better deal than covering a smaller room separately. A complete drywall installation will cost around $120 to $130 per sheet, depending on the area of the room.